Stack height = sine bar length x sin(angle). A 5 inch sine bar at 30 degrees needs a 2.5000 inch stack; at 15 degrees it needs 1.2941 inches.
L is the center distance between the rolls, not the overall bar length. Accuracy falls off above about 45 degrees, because a small stack error becomes a larger angle error as the cosine shrinks.
Tools that match your numbers
Sine bars in your bar length
Shown only for the bar lengths the listings give.
Nothing we carry is listed for that number. Change a value above, or compare the wider range below.
- Smaller option, below your numberSPI 13-186-2 Sine Bar: 5 inch Center-to-CenterUnder $100
Listed as a 5 in bar, matching the 5 in you entered; your setting needs a 2.5000 in gauge block stack.
Check price on Amazon - Smaller option, below your numberFowler 52-455-035-0Under $100
Listed as a 5 in bar, matching the 5 in you entered; your setting needs a 2.5000 in gauge block stack.
Check price on Amazon - Smaller option, below your numberHHIP 5 INCH SINE BARUnder $100
Listed as a 5 in bar, matching the 5 in you entered; your setting needs a 2.5000 in gauge block stack.
Check price on Amazon
Gauge blocks to build the stack
Matched on the range each listing gives against your stack height.
Nothing we carry is listed for that number. Change a value above, or compare the wider range below.
- Smaller option, below your numberHFS 81 PC Gauge Block Set Economy Grade Calibration NIST-TraceableUnder $250
Your stack height is 2.5000 in, inside the listed range (81 blocks, 0.050 to 4 in).
Check price on Amazon - Smaller option, below your numberBENCH WIZARD 36 Piece Steel Gauge Block SetUnder $100
Your stack height is 2.5000 in, inside the listed range (36 blocks, 0.1 to 4.0 in).
Check price on Amazon
Tools for this job
The tooling this calculation is usually for, spread across the price range.
How does the sine bar calculator work?
A sine bar turns an angle into a height, which gauge blocks can set to a ten-thousandth. That is the most accurate way a hobby shop can set or check an angle without a rotary table.
Frequently asked questions
What length sine bar should I buy?
A 5 inch sine bar suits almost every hobby job and fits a small surface plate and a 4 inch vise. A 10 inch bar halves the angle error for a given stack error, but needs a larger plate and taller stacks.
Keep going
Formulas are standard shop math; starting speeds are conservative conventions for hobby machines. Not professional engineering advice. Wear eye protection and keep hands, gloves and sleeves clear of rotating work.